A Guide To The Installation Of Synthetic Grass

Synthetic grass is quite a common product used for a wide variety of needs. Starting from football fields, to parks and play areas, to baseball fields, to a domestic garden this product is being used. Hence one of the most common concerns of this product users it the manner in which this product needs to be installed. Hence the following guide will help them install this product in no time and ready for usage.

#1 Ground Clearing

The first and foremost initiative when it comes to artificial turf Perth or any other state for that matter, is the cleaning up process of the location which the product needs to be installed. This could be a lawn, a playing field etc. or whatever it may be, regardless of how difficult this may be, it needs to be done at whatever cost. Special attention needs to be given to rocks and gravel.

#2 Levelling the Base

This is considered to be one of the most important steps in the process. This is basically to do with the levelling of the base. Generally the base needs to be started by leaving 3 to 4 inches below due to the grass or rather the artificial turf Perth would spread up to a height of approximately 4 inches. Hence the levelling needs to be started by leaving enough room for the spread of the grass. The basing should be solid and levelled equally at all places to avoid any harsh and tough corners as well as bumpy areas and uneven areas.

#3 Laying up the Synthetic Grass Layer

Thereafter what’s left to do is to lay the synthetic layer of grass into the levelled base and firmly fasten all the edges with absolutely no ripples and bumps on the layer. The most important thing to be concerned here is to ensure the layer is well stretched in order to make it look less synthetic and also to give a natural feeling when walked on it. it will also reduce the work load thereafter if the grass layer is stretched well because it makes it easy to cut and chop the excess parts of the layer from a single strike of a knife.

#4 Seaming and Reshaping

Once all that heavy work is over, the final step is to fine tune the implementation of the turf. Thereafter what needs to be done to slowly lift the grass layer which is not fasten to the base from the edges and either cut it off right from the edge using a knife or any sharp object. This needs to be done with extreme precision and caution in order to avoid and mistakes. After all no one would want to screw up at the last bit of any work.

By adhering to the above mentioned four simple steps, an effective installation of a synthetic layer of grass can be ensured.